Sony VAIO PCV-RX790G User Manual page 44

VAIO Digital Studio Computer User Guide
Editing captured video clips
1 After capturing your video clips to the Clip tray, click the
2 Drag your clips from the Clip tray to the Story Board panel at the bottom of
the MovieShaker™ window in the order you want them to appear in the
finished movie.
The Story Board panel represents the time sequence of your movie. You can
change the sequence of the clips on the Story Board panel by dragging them
to your desired location.
You can trim the beginning and end of any clip on the Story Board by
clicking it and moving the orange triangles on the Edit panel to set the start
and end point of the clip. Only the portion of the clip between the orange
triangles appears in the final movie.
3 To add transitions between clips on the Story Board panel, click Transition at
the right of the MovieShaker window to open the Transition tray, and drag a
transition from the list to the space between two clips on the Story Board.
4 To preview the entire movie, click the Story Board panel above the first clip
so that a white triangle appears above the clip, and click the Play button on
the Edit panel.
The entire movie, including transitions, plays in the monitor window.
After arranging, trimming and placing transitions in your video clips, you can
export your finished movie back to your DV device.
Exporting a finished movie to your DV camera
After you have created a finished movie, you can export it back to your
compatible DV or MICROMV™ device.
1 Make sure your camera is set to recording mode. On some devices this is
called VCR or VTR mode.
2 Turn on your DV or MICROMV device, and insert a videotape.
3 In MovieShaker, click Export in the lower right corner of the Story Board
tray.
44
(edit) tab.