Table of Contents
Advertisement
Appliance settings
en
Push the condensation container
3.
back into the appliance until you feel
it lock into place.
The filter in the condensation
Note:
container filters the condensation water,
which is used during the appliance's
automatic cleaning cycle. The filter is
cleaned by emptying out the
condensation water. You should still
check the filter regularly for any build-
up, and remove this if necessary.
~ "Cleaning the filter in the
condensation container" on page 52
32
2
Appliance settings
Y ou can activate/deactivate the
A p p l i a n c e s e t t i n g s
childproof lock and adjust the basic
settings (e.g. signals).
Childproof lock
Activating the childproof lock prevents
the settings from being accidentally
changed on the control panel.
Activating/deactivating the childproof
lock:
Press and hold Child Lock 3 sec.
■
for 3 seconds.
The childproof lock will remain
Note:
active, even once the appliance has
been switched off. If you wish to change
settings on the control panel when you
turn on the appliance, you will need to
deactivate the childproof lock.
Notification signal
You can activate or deactivate the
notification signal at the end of the
programme. If you activate this setting,
an audible signal will sound once the
programme has ended.
Activate/deactivate the appliance
setting as follows:
Press Signal .
The notification signal at the end of
programme is activated/deactivated.
If a signal does not sound when
Note:
the programme ends even though the
notification signal is activated, you can
change the appliance setting.
Advertisement
Table of Contents
