Table of Contents
Advertisement
Cleaning the base unit
This appliance is equipped with
automatic self-cleaning. Fluff from the
laundry does not have to be removed
after each use – it is collected in the
base unit.
In order to not adversely affect the
operation of the appliance, you must
clean the base unit (fluff collector and
fluff filter) only in the following cases:
The following message appears in
■
the display: õ
Before running the appliance care
■
programme.
As an option, you can clean the
appliance's base unit at any time.
Allow the appliance to cool down
Note:
for approximately 30 minutes after use
before commencing cleaning.
Clean the base unit as follows:
Open the maintenance flap by the
1.
handle.
Unlock the levers on the heat
2.
exchanger cover.
Cleaning and maintenance
Pull the heat exchanger cover out by
3.
its grip.
Remove all of the fluff from the heat
4.
exchanger cover and remove the
fluff filter.
Ensure that no dirt remains on
Note:
the seals of the heat exchanger
cover.
Rinse the inside of the heat
5.
exchanger cover and the fluff filter
thoroughly under running water and
dry them.
Notes
– You can use a soft brush to clean
off more stubborn dirt.
– Make sure you dry the fluff
collector's filter thoroughly after
rinsing it. If the fluff filter is damp,
this may increase the drying time
and affect the drying result.
en
49
Advertisement
Table of Contents
