Table of Contents
Advertisement
4.3 Autocutter Jam
If a foreign object such as a push pin or paper clip drops in the autocutter and causes the auto cutter to lock
up, the printer enters an error state and begins the recovery operation automatically.
If the problem is not serious, the autocutter returns to its normal position without any intervention by the
user.
If the autocutter does not return to its normal position by itself, follow the steps below to fix the problem:
1. Open the roll paper cover, and remove the jammed object if there is one.
2. Turn off the printer, and close the roll paper cover, and turn it back on. Then the cutter blade returns
to the normal position. If you would like not to turn off the printer, send an error recovery command
and initialize printer command instead.
3. If the cutter blade doesn't return to the normal position, return the cutter blade to the normal position
by rotating the autocutter knob in the direction of the arrow. When it is returned to the normal
position, a lever comes into the center of hole in the autocutter frame.
Autocutter unit
4. Close the roll paper cover.
4-4 Troubleshooting
Cutter cover
Hole
Knob
Lever
Advertisement
Table of Contents
