Table of Contents
Advertisement
The following sections describe the setup. The flow of preparing to use printer is listed below.
1. Printer setup
•Install Ribbon Cassette ("Installing or Replacing the Ribbon Cassette" (page 3-5))
•Install Paper Roll ("Installing the Roll Paper" (page 3-7))
•Connect the Printer to the Power Supply ("Connecting the AC Adapter" (page 3-9))
2. Adjust various setting ( If you need to)
When you use this printer with a serial interface, you have to adjust the communication settings.
See "Memory Switches" (page 3-14) for how to set them.
•Memory switches ("Memory Switches" (page 3-14))
The Memory switches set serial communication conditions, roll paper width, cover
open status handling, etc...
•Paper width ("Adjusting Roll paper width" (page 3-21))
The paper width is set by the spacer & Memory switch setting.
•Roll Paper Near End Detector (For model equipped with the detector)
("Adjusting Position of Roll Paper Near End Detector (factory option)" (page 3-22))
3. Connect the Printer to the Host PC/POS Terminal (and Cash Drawer)
("Install a Printer Driver in the Host PC / POS Terminal" (page 3-23))
4. Driver set up (If you use driver)
("Install a Printer Driver in the Host PC / POS Terminal" (page 3-23))
5. Complete the setup
TM-U330 Technical Reference Guide
Setup 3-4
Advertisement
Table of Contents
