Table of Contents
Advertisement
Part IV: Operation
Remote Control Functions: Channel Selection and Sleep Timer
Channel Selection
For Non-DTV Channels:
Enter three numbers (for channel 2,
press 002).
or
Press the channel number and ENTER
(for channel 2, press 2, then ENTER).
or
Enter the channel number and wait four
seconds. The TV will change automati-
cally.
Remote Control Functions: Active A/V Network
The Active A/V Network is a special feature
that makes it easier to use your TV and
Mitsubishi VCR. When the A/V Network is
connected, you can point the remote control
at the TV, and it will pass the remote control
command to your VCR.
Before You Begin
See Connecting the Active A/V Network,
page 22, to insure correct installation.
See SETUP Menu: A/V Connection
(Home Theater), page 32, to insure cor-
rect setup.
Set your VCR's remote control settings
to VCR or VCR A (when your VCR has
an A/B setting).
56
56
Sleep Timer
Setting the Sleep Timer:
Press SLEEP on the remote control.
A message box indicating the length of
time the sleep timer is to be set for is
displayed on the TV screen.
Each press of SLEEP will increase
the time displayed by 30 minutes, until
the maximum value of 120 minutes is
reached.
After 5 seconds of inactivity, the mes-
sage box will disappear.
Press SLEEP to view the remaining time
before the timer turns the TV off.
Canceling the Sleep Timer:
Press SLEEP to display the on-screen
message box.
Press SLEEP repeatedly until OFF is
displayed.
After 5 seconds of inactivity, the mes-
sage box will disappear.
Turn the VCR's video mute setting to on.
Turn the VCR's Active A/V Network fea-
ture to active.
Operation with Your VCR
(when slide switch is set to TV or VCR)
Pressing PLAY on the TV remote control
will:
Turn the TV on and select input-1.
Turn the VCR on and play a tape (if a
tape is properly loaded in the VCR).
When the slide switch is set to TV, pressing
POWER on the TV remote control will turn
the TV and VCR off, unless the VCR is play-
ing or recording.
Advertisement
Table of Contents
