Ready In Time; Memory Programme; Remote Start - Bosch WAT286H9IN Instruction Manual And Installation Instructions

Programme default settings
en

Ready in time

After selecting a programme, the
programme duration is displayed, e.g.
1:51 (in h:min (hours:minutes)).
Before the programme starts, you can
move the time at which the programme
should be finished backwards, in
increments of 30 minutes and up to a
maximum of 24 h (h=hour).
After the programme starts, the
selected time, e.g. 8.5 h is displayed
and counted down until the washing
programme starts. The duration of the
programme is then displayed.
The programme duration is
Note:
automatically adjusted when the
programme is running. Changes to the
programme default settings or
programme settings, foam detection
function, unbalanced load detection, the
load or soiling may also change the
programme duration.
After the programme starts, and while
the selected time is counting down, you
can change this as follows:
Touch the control panel A.
1.
Touch N or M to change the time.
2.
And touch A again.
3.
After starting the programme, while the
programme is running, you can add or
remove laundry if necessary.
~ Page 31

Memory programme

â
You can save a selected programme
with your favourite settings here.
To store:
Switch on the appliance.
1.
Select a programme.
2.
Change the settings and/or select
3.
additional settings.
Press and hold â on the control
4.
panel for approx. three seconds.
26
The programme is saved if all of the
settings flash briefly.
To use the saved programme, touch â
briefly after you switch on the appliance.
To change the saved programme, press
and hold â again for approx. three
seconds after selecting the new
settings.

Remote start

}
Pressing Remote start } allows you to
start the appliance remotely via the
Home Connect app or to call up the
Home Connect settings.
Enabling the appliance to be started
remotely via the Home Connect app:
Remote start can only be
Note:
activated if the appliance door and the
detergent drawer are closed and the
appliance is connected to your home
network.
Briefly press Remote start.
■
Remote start will be
Note:
deactivated for safety reasons in the
following circumstances:
When the door is opened,
When the detergent drawer is
opened,
In the event of a power failure,
When a programme has come to an
end,
When Start/Pause A is pressed on
the appliance,
When Remote start is pressed
briefly again,
When # is pressed to switch off the
appliance.
Calling up Home Connect settings:
Press and hold Remote start for at
■
least 3 seconds.