Asus P8H77-I Manual page 40

8. Intel H77 Serial ATA 6.0Gb/s connectors (7-pin SATA6G_1/2 [gray])
®
These connectors connect to Serial ATA 6.0 Gb/s hard disk drives via Serial ATA 6.0
Gb/s signal cables.
• These connectors are set to [AHCI] by default. If you intend to create a Serial ATA RAID
• Before creating a RAID set, refer to the RAID Supplementary Guide included in the
• You must install Windows
• When using hot-plug and NCQ, set the SATA Mode Selection item in the BIOS to
9. USB 3.0 connector (20-1 pin USB3_34)
This connector is for the additional USB 3.0 ports. Connect the USB 3.0 bracket cable
to this connector, then install the USB 3.0 bracket to the rear side of the chassis. If your
chassis support customized front panel installation, with ASUS USB 3.0 header, you
can have a front panel USB 3.0 solution.
P8H77-I USB3.0 Front panel connector
The USB 3.0 module is purchased separately.
1-30
SATA6G_1
SATA6G_2
set using these connectors, set the SATA Mode Selection item in the BIOS to [RAID].
See section 2.5.3 SATA Configuration for details.
folder named Manual in the support DVD.
hard disk drives. The Serial ATA RAID feature (RAID 0, 1, 5, and 10) is available only if
you are using Windows
®
[AHCI]. See section 2.5.3 SATA Configuration for details.
XP Service Pack 3 or later version before using Serial ATA
®
XP SP3 or later version.
Chapter 1: Product introduction