Table of Contents
Advertisement
Drive System
Maintenance
Checking the Seat Belt
Service Interval: Before each use or daily
Inspect the seat belt for wear, cuts, and proper
operation of the retractor and buckle. Replace the
seat belt if it is damaged.
Adjusting the Tracking
1.
Disengage the blade-control switch (PTO).
2.
Drive to an open, flat area and move the
motion-control levers to the N
position.
3.
Move the throttle midway between the F
S
positions.
LOW
4.
Move both motion-control levers forward until
they both hit the stops in the T-slot.
5.
Check which way the machine tracks.
6.
If the machine tracks to the right, insert a 3/16
inch hex wrench through the access hole in the
left, front cover panel and rotate the tracking
screw clockwise or counterclockwise to adjust
the travel of the lever
7.
If the machine tracks to the left, insert a 3/16
inch hex wrench through the access hole in the
right, front cover panel and rotate the tracking
screw clockwise or counterclockwise to adjust
the travel of the lever
8.
Drive the machine and check the full forward
tracking.
9.
Repeat the adjustment until the desired tracking
is obtained.
-
EUTRAL
LOCK
and
AST
(Figure
61).
(Figure
61).
Right control lever shown
1. Tracking screw
51
Figure 61
2. Access hole on the front
cover panel
g334735
Advertisement
Table of Contents
