Table of Contents
Advertisement
Problem
The water in the cavity em-
bossment does not boil.
The water comes out of the
cavity embossment.
SERVICE DATA
If you cannot find a solution to the problem yourself,
contact your dealer or an Authorised Service
Centre.
The necessary data for the service centre is on the
rating plate. The rating plate is on the front frame of
Model (MOD.)
Product number (PNC)
Serial number (S.N.)
ENERGY EFFICIENCY
PRODUCT INFORMATION FOR HOB ACCORDING TO EU 66/2014
Model identification
Type of hob
Number of cooking zones
Heating technology
Diameter of circular cooking
zones (Ø)
Energy consumption per cooking
zone (EC electric cooking)
Energy consumption of the hob (EC electric hob)
24
Possible cause
The temperature is too low.
There is to much water in the
cavity embossment.
We recommend that you write the data here:
ZCV69068XE
Hob inside Freestanding Cooker
4
Radiant Heater
Left front
Left rear
Right front
Right rear
Left front
Left rear
Right front
Right rear
Set the temperature at least to
110°C. Refer to "Hints and
Tips" chapter.
Deactivate the oven and make
sure that the appliance is cold.
Wipe the water with a cloth or
sponge. Add the correct
amount of water to the cavity
embossment. Refer to "Activat-
ing the Plus Steam function".
the oven cavity. Do not remove the rating plate from
the oven cavity.
.........................................
.........................................
.........................................
Remedy
18.0 cm
14.5 cm
14.5 cm
18.0 cm
177.3 Wh/kg
180.3 Wh/kg
180.3 Wh/kg
179.4 Wh/kg
179.3 Wh/kg
Advertisement
Table of Contents
