Table of Contents
Advertisement
Click TEMP. UP or TEMP. DOWN to change 00 to the
desired address as shown in Fig. 37. Press OK to confirm and
exit the setting interface.
MODE
TEMP. UP
ROOM TEMP.
FAN
TEMP. DOWN
Fig. 37 —Non-Programmable Controller Setting
IDU Address
Programmable Controller —
address, connect only one wired controller to an indoor unit.
1. Press FAN and BACK simultaneously for five seconds to
access parameter settings as shown in Fig. 38.
MODE
MENU
FAN
TEMP. DOWN
Fig. 38 — Programmable Controller IDU
Addressing Menu
ON/OFF
TIMER
SWING
OK
When setting an
TEMP. UP
ON/OFF
OK
BACK
2. Press TEMP. UP or TEMP. DOWN to move the cursor
and choose IDU ADDRESSING. Press MENU/OK to
access this setting.
3. Press TEMP. UP or TEMP. DOWN to choose the
address you want to set as shown in Fig. 39. Press
MENU/OK to send this address to the IDU.
MODE
FAN
Fig. 39 —Programmable Controller Setting IDU
4. Press BACK twice or wait 30 seconds to automatically
exit the parameter settings menu.
23
TEMP. UP
ON/OFF
MENU
OK
TEMP. DOWN
BACK
Address
Advertisement
Table of Contents
