Non-Programmable Controller; Programmable Controller - Carrier 40VMF Installation And Maintenance Instructions Manual

AUTO
COOL
1 – MODE SETTING DRY
HEAT
FAN
MODE
3 – ADJUST DOWN
5 – ON/OFF
7 – AIR VERT. SWING
SWING
8 – AIR HORIZ. SWING
SWING
RESET LOCK C/H
12 – RESET
13 – LOCK
15 – COOL/HEAT
Fig. 24 —Wireless Remote Controller
(40VM900001)
Use a tool to press and hold the LOCK button for at least 10
seconds, then press to activate. Click
address and press to send the setting.
To display an indoor unit address, use a tool to press and hold
the LOCK button for at least 10 seconds, and press
the addresses.
Non-Programmable Controller —
address, connect only one wired controller to an indoor unit.
Press ROOM TEMP and SWING simultaneously for three
seconds. If there is no address for this indoor unit, the display
shows FE# 00 as shown in Fig. 25. Otherwise, the display
shows the current address of the indoor unit.
MODE
ROOM TEMP.
FAN TEMP. DOWN
Fig. 25 —Non-Programmable Controller IDU
Addressing Menu
TEMP
SET
2 – FAN SPEED SETTING
CLOCK
SET
HOUR
FAN SPEED
4 – ADJUST UP
FAN
6 – AIR DIRECTION
9 – CLOCK SETTING
10 – TIMER ON
AIR DIRECTION CLOCK
11 – TIMER OFF
TIMER ON
OK
TIMER OFF
14 – OK (CONFIRM)
A40-1734
or to select an
to query
When setting an
TEMP. UP ON/OFF
TIMER SWING
OK
Click TEMP. UP or TEMP. DOWN to change 00 to the de-
sired address as shown in Fig. 26. Press OK to confirm and
exit the setting interface.
MODE
ROOM TEMP.
FAN
Fig. 26 —Non-Programmable Controller Setting
Programmable Controller —
address, connect only one wired controller to an indoor unit.
1. Press FAN and BACK simultaneously for five seconds to
access parameter settings as shown in Fig. 27.
MODE
FAN
Fig. 27 —Programmable Controller IDU
Addressing Menu
2. Press TEMP. UP or TEMP. DOWN to move the cursor
and choose IDU ADDRESSING. Press MENU/OK to
access this setting.
15
TEMP. UP ON/OFF
TIMER SWING
OK
TEMP. DOWN
IDU Address
When setting
TEMP. UP ON/OFF
MENU
OK
TEMP. DOWN BACK
an