Setup; Loose Parts; Installing The Front Casters - Toro 30520 Operator's Manual

Setup

Note: Determine the left and right sides of the machine from the normal operating position.

Loose Parts

Note: Use the chart below to verify all parts have been shipped.
DESCRIPTION
Caster assemblies
Bolt, 3/8 x 3/4 in.
Flange nut, 3/8 in.
Upper handle
Flanged bolt, 3/8 x 1 in.
Flanged nut, 3/8 in.
Wire tie
Clevis pin
Washer
Hairpin cotter
Fuel tank
Bolt, 5/16 x 3/4 in.
Lock washer, 5/16 in.
Locknut
Washer, 5/16 in.
Stud
Spring
Operator's Manual
Engine Operator's Manual
Parts Catalog
Video
Registration card

Installing the Front Casters

1. Align the casters with the holes on the top and front of
the mower, and insert 8 bolts (3/8 x 3/4 in.) through the
mower. Secure the casters with 8 flange nuts (3/8 in.)
below the mower (Fig. 2).
QTY.
2
Installing the front casters
8
8
1
4
Installing the upper handle and wire harness
4
2
2
Installing the control rods
2
2
1
2
2
2 Installing the fuel tank
4
2
2
1
1 Review before operating machine
1
1
1 Fill out and return to Toro
13
USE