Toro 30864A Operator's Manual page 23

Fuel Table
Diesel fuel specification
ASTM D975
No. 1-D S15
No. 2-D S15
EN 590
ISO 8217 DMX
JIS K2204 Grade No. 2
KSM-2610
•
Use only clean, fresh diesel fuel or biodiesel fuels.
•
Purchase fuel in quantities that can be used within
180 days to ensure fuel freshness.
Use summer-grade diesel fuel (No. 2-D) at
temperatures above -7°C (20°F) and winter-grade
fuel (No. 1-D or No. 1-D/2-D blend) below that
temperature.
Note:
Use of winter-grade fuel at lower temperatures
provides lower flash point and cold flow characteristics
which eases starting and reduces fuel filter plugging.
Using summer-grade fuel above -7°C (20°F)
contributes toward longer fuel pump life and increased
power compared to winter-grade fuel.
Biodiesel
This machine can also use a biodiesel blended fuel of
up to B20 (20% biodiesel, 80% petroleum diesel).
Sulfur content: Ultra-low sulfur (<15 ppm)
Biodiesel fuel specification: ASTM D6751 or
EN14214
Blended fuel specification: ASTM D975, EN590,
or JIS K2204
Important:
The petroleum diesel portion must
be ultra-low sulfur.
Observe the following precautions:
•
Biodiesel blends may damage painted surfaces.
•
Use B5 (biodiesel content of 5%) or lesser blends
in cold weather.
•
Monitor seals, hoses, gaskets in contact with fuel
as they may be degraded over time.
•
Fuel filter plugging may be expected for a time
after converting to biodiesel blends.
•
Contact your Authorized Toro Distributor if you
wish for more information on biodiesel.
Location
USA
European Union
International
Japan
Korea
Fuel Tank Capacity
Fuel tank capacity: 53 L (14 US gallons)
Adding Fuel
1. Park the machine on a level surface.
2. Using a clean rag, clean area around fuel tank
cap.
3. Remove the cap from the fuel tank
1. Fuel tank cap
4. Fill the tank until the level is 6 to 13 mm (1/4 to
1/2 inch) below the bottom of the filler neck.
5. Install fuel tank cap tightly after filling tank.
Note:
If possible, fill the fuel tank after each
use. This will minimize possible buildup of
condensation inside the fuel tank.
Fill the tank to about 6 to 13 mm (1/4 to 1/2 inch)
below the top of the tank, not the filler neck, with
Number 2-D diesel fuel.
Note:
If possible, fill the fuel tank after each use; this
will minimize possible buildup of condensation inside
the fuel tank.
23
(Figure
Figure 17
17).
g021210