Toro 30864A Operator's Manual page 16

Parking Brake
To engage the parking brake,
on the brake pedal and press the top forward to latch.
To release the parking brake, press the brake pedal
until the parking brake latch retracts.
1. Traction pedal
2. Mow speed limiter
3. Spacers
Brake Pedal
Press the brake pedal
Tilt Steering Pedal
To tilt the steering wheel towards you, press the foot
pedal (Figure 9) down, and pull the steering tower
toward you to the most comfortable position and then
release the pedal.
Engine Speed Switch
The engine speed switch
to change the engine speed. By momentarily tapping
the switch, the engine speed can be increased or
decreased in 100 rpm increments. By holding the
switch down the engine will automatically move to
High or Low idle, depending on which end of the
switch is depressed.
(Figure 9) push down
Figure 9
4. Brake pedal
5. Parking brake
6. Tilt steering pedal
(Figure 9) to stop the machine.
(Figure 10) has two modes
1. Lower mow/raise control
lever
2. Key switch
3. InfoCenter
Key Switch
The key switch
g003955
On/Preheat, and Start.
Lower Mow/Raise Control Lever
This lever (Figure
decks and also starts and stops the mowers when the
mowers are enabled in the mow mode. When starting
the decks in the down position, this lever will turn the
decks on if the PTO and the mow speed limiter are
engaged.
Headlight Switch
Pivot the switch downward to turn on the headlights
(Figure 10).
Enable/Disable Switch
Use the enable/disable switch
conjunction with the lower mow/raise control lever to
operate the mowers. The mowers cannot be lowered
when the mow/transport lever is in the transport
position.
InfoCenter
The InfoCenter LCD display shows information about
your machine such as the operating status, various
diagnostics and other information about the machine
(Figure 10).
16
Figure 10
4. Enable/disable switch
5. Engine speed switch
6. Headlight switch
(Figure 10) has three positions: Off,
10) raises and lowers the cutting
(Figure
g021208
10) in