Yamaha YZ85 2013 Owner's Manual page 80

MOTORCYCLE CARE AND STORAGE
detergent residue using plenty
of water, as it is harmful to plas-
tic parts.
 Do not use any harsh chemical
products on plastic parts. Be
sure to avoid using cloths or
sponges which have been in
contact with strong or abrasive
cleaning products, solvent or
thinner, fuel (gasoline), rust re-
movers or inhibitors, brake fluid,
antifreeze or electrolyte.
 Do not use high-pressure wash-
ers or steam-jet cleaners since
they cause water seepage and
deterioration in the following ar-
eas: seals (of wheel and swing-
arm bearings, fork and brakes),
electric components (couplers,
connectors, and
8
breather hoses and vents.
After normal use
Remove dirt with warm water, a mild
detergent, and a soft, clean sponge,
and then rinse thoroughly with clean
water. Use a toothbrush or bottlebrush
for hard-to-reach areas. Stubborn dirt
and insects will come off more easily if
the area is covered with a wet cloth for
a few minutes before cleaning.
After riding in the rain or near the sea
Since sea salt is extremely corrosive,
carry out the following steps after each
ride in the rain or near the sea.
1. Clean the motorcycle with cold
water and a mild detergent, after
the engine has cooled down.
NOTICE: Do not use warm wa-
ter since it increases the corro-
sive action of the salt.
2. Apply a corrosion protection spray
on all metal, including chrome-
and nickel-plated, surfaces to pre-
vent corrosion.
After cleaning
switches), 1. Dry the motorcycle with a chamois
or an absorbing cloth.
2. Immediately dry the drive chain
and lubricate it to prevent it from
rusting.
3. Use a chrome polish to shine
chrome, aluminum and stainless-
steel parts, including the exhaust
system.
4. To prevent corrosion, it is recom-
5. Use spray oil as a universal clean-
6. Touch up minor paint damage
7. Wax all painted surfaces.
8. Let the motorcycle dry completely
[ECA10792]
Contaminants on the brakes or tires
can cause loss of control.
 Make sure that there is no oil or
 If necessary, clean the brake
8-2
mended to apply a corrosion pro-
tection spray on all
including chrome- and nickel-plat-
ed, surfaces.
er to remove any remaining dirt.
caused by stones, etc.
before storing or covering it.
WARNING
wax on the brakes or tires.
discs and brake linings with a
regular brake disc cleaner or
acetone, and wash the tires with
warm water and a mild deter-
gent. Before riding at higher
speeds, test the motorcycle's
braking performance and cor-
nering behavior.
metal,
EWA11132