Rear Wheel - Yamaha YZ85 2013 Owner's Manual

PERIODIC MAINTENANCE AND ADJUSTMENT
3. Remove the axle nut and washer.
4. Pull the wheel axle out, and then
remove the wheel. NOTICE: Do
not apply the brake after the
wheel and brake disc have been
removed, otherwise the brake
pads will be forced shut.
1. Wheel axle
7
To install the front wheel
1. Lift the wheel up between the fork
legs.
TIP
Make sure that there is enough space
between the brake pads before install-
ing the wheel.
2. Insert the wheel axle from the right
side.
3. Lower the front wheel so that it is
on the ground, install the remov-
able sidestand, and then rest the
motorcycle on it.
4. Install the washer and axle nut,
and then tighten the axle nut to the
specified torque.
[ECA11073]
Tightening torque:
Axle nut:
70 Nm (7.0 m·kgf, 51 ft·lbf)

Rear wheel

To remove the rear wheel
To avoid injury, securely support the
vehicle so there is no danger of it
falling over.
1. Loosen the axle nut.
2. Lift the rear wheel off the ground
3. Fully loosen the locknut, and then
4. Remove the axle nut and washer.
7-29
WARNING
according to the procedure on
page 7-28.
loosen the drive chain slack ad-
justing bolt on each side of the
swingarm.
EAU25081
EAU56741
EWA10822