Table of Contents
Advertisement
KX-FT932BR-B
10 Test Mode
The codes listed below can be used to perform simple checks for some of the unit's functions. When complaints are received
from customers, they provide an effective tool for identifying the locations and causes of malfunctions. To do this, you set the
Service mode (Refer to Operation Flow (P.56).) first, then operate the below test items.
Test Mode
Type of Mode
FACTORY SET
Service Mode
FLASH
MEMORY
Service Mode
CHECK
MODEM TEST
Service Mode
SCAN CHECK
Service Mode
MOTOR TEST
Service Mode
LED CHECK
Service Mode
LCD CHECK
Service Mode
KEY CHECK
Service Mode
MEMORY CLEAR
Service Mode
(except History data)
SENSOR CHECK
Service Mode
PRINT TEST PAT-
Service Mode
TERN
Note:
The numbers in the boxes (XXX) indicate the keys to be
input for the various test modes.
Code
Operation after code
input
"5" "5" "0"
Refer to Memory Clear Specification (P.59).
SET
"5" "5" "1"
Indicates the version and checks the sum of the FLASH MEMORY.
SET
"5" "5" "4"
Telephone line circuit is connected automatically, output the following signals on
the circuit line.
SET
1) OFF 2) 9600bps 3) 7200bps 4) 4800bps 5) 2400bps 6) 300bps 7) 2100Hz
8) 1100Hz
"5" "5" "5"
Turns on the LEDs of the CIS and operates the read systems.
Refer to CIS (Contact Image Sensor) Section (P.115).
SET
"5" "5" "6"
Rotates the transmission and reception motor to check the operation of the motor.
12: FAX TX / Reading memory
SET
52: Recording paper is fed
22: Copy
44: Recording Paper reverse
Press [STOP] button to quit.
"5" "5" "7"
All LEDs above the operation panel board flash on and off, or are illuminated.
SET
"5" "5" "8"
Checks the LCD indication.
Illuminates all the dots to check if they are normal.
SET
Refer to Operation Panel Section (P.113).
"5" "6" "1"
Checks the button operation.
Indicates the button code on the LCD while the button is pressed. Refer to But-
START (any key)
ton Code Table (P.55).
Refer to Operation Panel Section (P.113).
"7" "1" "0"
Refer to Memory Clear Specification (P.59).
SET
"8" "1" "5"
If you enter this mode and operate sensor levers with your hands, the LCD dis-
play of the related sensor (or switch) turns ON / OFF. Also, when copying a doc-
SET
ument, the related sensor will turn ON / OFF.
For each sensor's operation, refer to Sensors and Switches (P.26).
Do Sn Co Jm : LCD DISPLAY
Do: Document set sensor
:Paper inserted. Turns on when a document is inserted.
Sn: Read position sensor.
:At the read position, turns on when the front cover is opened and the sensor
lever is pressed directory.
Co: Cover open sensor
:Turns on and off when the front cover is opened and closed.
Jm: JAM sensor
:When JAM sensor is on "Jm" functions.
"8" "5" "2"
Prints out the test pattern.
Used mainly at the factory to test the print quality.
SET
You can select 1~9. (See Print Test Pattern (P.55))
54
Function
Advertisement
Table of Contents
Troubleshooting
