Table of Contents
Advertisement
KX-FT981LA-B / KX-FT987LA-B
10 Test Mode
The codes listed below can be used to perform simple checks for some of the unit's functions. When complaints are received
from customers, they provide an effective tool for identifying the locations and causes of malfunctions. To do this, you set the
Service mode (Refer to Operation Flow (P.58).) first, then operate the below test items.
Test Mode
Type of Mode
MEMORY CLEAR
Service Mode
FLASH MEMORY
Service Mode
CHECK
DTMF SINGLE TONE
Service Mode
TEST
MODEM TEST
Service Mode
SCAN TEST
Service Mode
MOTOR TEST
Service Mode
LED TEST
Service Mode
LCD TEST
Service Mode
KEY TEST
Service Mode
CUTTER TEST
Service Mode
(KX-FT987 only)
MEMORY CLEAR
Service Mode
(except History data)
VOICE PROMPT TEST
Service Mode
(KX-FT987 only)
Code
Operation after code
input
[5] [5] [0]
Refer to Memory Clear Specification (P.61).
[SET]
[5] [5] [1]
Indicates the version and checks the sum of the FLASH MEMORY.
[SET]
[5] [5] [2]
Outputs the DTMF as single tones. Used to check the frequencies of the individ-
ual DTMF tones. Refer to DTMF Single Tone Transmit Selection (P.56).
[1]: ON
[2]: OFF
[5] [5] [4]
Telephone line circuit is connected automatically, output the following signals on
the circuit line.
[SET]
1) OFF 2) 9600bps 3) 7200bps 4) 4800bps 5) 2400bps 6) 300bps 7) 2100Hz
8) 1100Hz
[5] [5] [5]
Turns on the LEDs of the CIS and operates the read systems.
Refer to CIS (Contact Image Sensor) Section (P.125).
[SET]
[5] [5] [6]
Rotates the transmission and reception motor to check the operation of the motor.
[SET]
02: FAX TX / Reading memory
06: Cutter (KX-FT987 only)
08: Recording paper is fed
10: Copy
13: Recording Paper reverse
Press [STOP] button to quit.
[5] [5] [7]
All LEDs above the operation panel board flash on and off, or are illuminated.
[SET]
[5] [5] [8]
Checks the LCD indication.
Illuminates all the dots to check if they are normal.
[SET]
Refer to No LCD Indication (P.122).
[5] [6] [1]
Checks the key operation except [STOP] key.
Indicates the button code on the LCD while the button is pressed, see Button
The available key is
Code Table (P.56)
any one that except
Refer to No Key Operation (P.122).
[STOP] key.
[5] [6] [2]
Perform cutter test 10 times.
[SET]
[7] [1] [0]
Refer to Memory Clear Specification (P.61).
[SET]
[7] [8] [4]
You can hear the voice prompt from speaker after pressing "SET" key.
[SET]
54
Function
Advertisement
Table of Contents
Troubleshooting
