Adjusting Throttle Cable; Throttle Lever - Kubota Z122E Operator's Manual

50 PERIODIC SERVICE
BAdjusting Throttle Cable
[Z122E, Z125E]
1. Move the throttle lever to the "FAST" position.

(1) Throttle lever

2. Attempt to pass a pin (A) with a diameter of 3 mm
through the holes indicated.
(1) Bolt
(2) Throttle lever cable sheath
3. If not possible, loosen the bolt (1) and pull the throttle
lever cable sheath (2) in the direction of the arrow so
that the pin (A) passes through all the required holes
(B). And then tighten the bolt (1).
(A) Pin with a diameter of 3 mm
(B) Hole
(P) "PULL"
[Z121S, Z125S]
1. Move the throttle lever to the "FAST" position.
(1) Throttle lever
2. Make sure the throttle arm (A) contacts the choke arm
(B).
(1) Bolt
(2) Throttle lever cable sheath
3. If not possible, loosen the bolt (1) and pull the throttle
lever cable sheath (2) in the direction of the arrow until
throttle arm (A) contact the choke arm (B). And then
tighten the bolt (1).
(A) Throttle arm
(B) Choke arm
(P) "PULL"
(Q) "CONTACT"