Troubleshooting - Masterbuilt ES40G1.5DW1 Manual

Troubleshooting

SYMPTOM
Power light won't come on
Smoker takes excessive amount of
time to heat up (longer than 60-70
min)
There is a gap between the door and
the smoker when in use and door latch
has no more adjustment
Grease is leaking out of smoker
through door and legs
No smoke
No smoke at low setting
Temperature rapidly decreased, or
shut down after a few hours of use
Controller displaying error message
Power light is on but smoker isn't
heating
Controller does not adjust heat
Meat probe temperature does not
show on display
CAUSE
Not plugged into wall
House breaker tripped
Wire connector on controller not
properly connected to smoker
Controller malfunctioning
Smoker plugged into an extension
cord
Door not closed properly
Controller malfunctioning
Door alignment
Damaged door seal
Drip pan not in place
Excess grease or oil build-up in
smoker
Drain tube in back of smoker is not
draining
No wood chips
Not enough heat to induce smoking
Internal wiring issue
Temperature sensor malfunctioning
Element failure
Controller/smoker malfunctioning
Meat probe malfunctioning
POSSIBLE SOLUTION
Check wall connection
Make sure other appliances are not
operating on the same electrical
circuit. Check household breakers.
See step 5
Contact Masterbuilt at
www.masterbuilt.com/pages/contact-us
Set smoker so extension cord does
not have to be used
Close door and fasten latch
securely
Contact Masterbuilt at
www.masterbuilt.com/pages/contact-us
Contact Masterbuilt at
www.masterbuilt.com/pages/contact-us
Reposition so hole lines up with
drain hole in bottom of smoker
Clean smoker
Check drain tube positioning at
back of smoker
Add wood chips
Increase temp to 275° F for 8 to 10
minutes, or when woodchips begin
to smolder then reduce to desired
low setting
Contact Masterbuilt at
www.masterbuilt.com/pages/contact-us
Contact Masterbuilt at
www.masterbuilt.com/pages/contact-us
Contact Masterbuilt at
www.masterbuilt.com/pages/contact-us
Contact Masterbuilt at
www.masterbuilt.com/pages/contact-us
Contact Masterbuilt at
www.masterbuilt.com/pages/contact-us
15