Table of Contents
Advertisement
Quick wash
This program is used for glasses and porcelain that is lightly
soiled, such as coffee cups.
Super Quick wash
Short program lasting about 15 minutes with acceptable results
for very lightly soiled dishes.
Delicate wash
If the dishes are only lightly soiled, you can select Delicate wash.
This program is intended for glasses and porcelain that have just
been used and as such do not require such a powerful program.
This program can be used for fragile dishes. Select Short dry if
you want to be especially cautious. See also the section Fragile
dishes in the chapter Loading the dishwasher.
Eco wash
Use when you want to save energy. For normally soiled dishes.
Rinse & Dry
This program consists of a rinse with heating and drying. This is
a suitable program if, for example, you plan to make jam and
want to rinse and heat clean glass jars.
Rinse & Hold
Use to rinse dishes while you wait for the dishwasher to become
fully loaded.
Selecting Options
To select an option, press one of the option buttons. The field
under the button lights when the option is activated. The available
options depend on the selected program. Once you have started
the program, the options you selected are saved for the next time
you use the same program.
High temperature
Activate this option for improved dishwashing results. The
machine then uses a higher temperature for the main wash.
If you want to use the lower temperature, press again so that the
field under the button turns off.
You can vary the temperature as shown below:
Sanitation wash:
Normal wash:
Heavy wash:
Quick wash:
Super Quick wash:
Delicate wash:
Eco wash:
8
130 °F (55 °C) / 160 °F (70 °C)
130 °F (55 °C) / 150 °F (65 °C)
140 °F (60 °C)/150 °F (65 °C)
85 °F (30 °C) / 140 °F (60 °C)
85 °F (30 °C) / 140 °F (60 °C)
105 °F (40 °C) / 120 °F (50 °C)
120 °F (50 °C) / 140 °F (60 °C)
Customer Care Center 1-800-898-1879
Long dry
A higher temperature in the final rinse and a longer drying phase
improves the drying result if you activate the Long dry option.
This causes a slight increase in energy consumption. This option
can be used with all programs except Rinse & Dry and Rinse &
Hold.
If you want a program with Short dry, press again so that the field
under the button turns off.
Start the dishwasher
Press and hold Start/Stop until the display shows
open symbol). This indicates that the dishwasher is ready to start.
Close the door properly, otherwise the dishwasher will not start.
NOTE!
If the machine does not start within 2 minutes of the last button
press, the display returns to showing the last program run.
Time remaining
Once you have selected a program and options, the display
indicates how long the program took the last time it was used.
The remaining time is updated after the water for the final rinse
has been heated.
This may differ somewhat from time to time depending on the
temperature of the water supply, the amount of dishes, the
ambient temperature, and other factors.
NOTE!
During the first run of each program, the remaining time
displayed can be slightly misleading, as the dishwasher is
estimating the time. When you run the program a second time,
the dishwasher will calculate the remaining time based on the
previous duration of the program.
Stopping or changing a program
If you want to change programs after starting the dishwasher,
open the door then press and hold Start/Stop for three seconds.
Add more detergent if the lid of the detergent dispenser has
opened. Then choose a new program, press Start/Stop, and close
the door.
Do you want to add more dishes?
Open the door. The dishwasher stops automatically. Add the
dishes, close the door, and the dishwasher resumes the program.
If the dishwasher is turned off using
the On/Left-on mode button or due
to a power failure
If the program was not finished, the interrupted program resumes
when power is restored.
NOTE!
During drying, the program is interrupted if the power is cut or
the door is open for more than 2 minutes.
www.askona.com
(the door
Advertisement
Table of Contents
