Selecting A Built-In Font - Epson LQ-300+II User Manual

❏ Flashes when the print head has overheated.
* Font select : In the Micro Adjust mode, you can select the font to use for
printing by pressing the Tear Off (Font) button. The Tear Off (Font) lights turn
on, off or flash to indicate the selected font.
** Micro Adjust mode : When you hold down the Pause button for three
seconds, the printer enters the micro adjust mode. In this mode, you can
press the LF/FF D and Load/Eject U buttons to adjust the top-of-form or
tear-off position. See "Adjusting the top-of-form position" on page 25.

Selecting a built-in font

Follow these steps to select a built-in font using the buttons on the
printer's control panel:
1. Make sure that the printer is not printing. If it is, wait until
printing is complete.
2. Hold down the Pause button for three seconds to enter the
Micro Adjust mode. The Pause light begins to flash. The three
Tear Off (Font) lights show the current font selection.
3. Press the Tear Off (Font) button repeatedly to cycle through
all of the available selections; then stop when you reach the
desired font with a pattern shown on the control panel. Your
selection stays in effect until you change it again.
Note:
❏ Settings you make in your application programs usually
override settings you make from the printer's control panel. For
best results, use your application to select a font and pitch.
❏ The Tear Off (Font) button cannot directly select OCR-B,
Orator, Orator-S, Script C, Roman T, or Sans Serif H. To select
one of these fonts, you must first use the Default Setting mode
to register it as the "other" font and then select Others using
the Tear Off (Font) button.
❏ Bar code fonts cannot be selected via the control panel.
87