Advertisement
TROUBLESHOOTING
CHART
PROBLEM
CAUSE
CORRECTION
Will not start
Hard to start
Enginewill not
turn over
Engine clicks but
will not start
i 1. Out of fuel.
2. Engine not "CHOKED"
properly.
3. Engine flooded.
4. Bad spark plug.
5. Dirty air filter.
6. Dirty fuel filter.
7
Water in fuel.
8. Loose or damaged wiring.
9. Carburetor
out of adjustment
10.Engine valves out of
adjustment.
1. Dirty air filter.
2. Bad spark plug,
3. Weak or dead battery.
4. Dirty fuel filter.
5. Stale or dirty fuel.
6. Loose or damaged
wiring.
7. Carburetor out of adjustment
8. Engine valves out of
adjustment.
1. Clutch/brake
pedal not
depressed.
2. Attachment clutch is
engaged.
3. Weak or dead battery.
4. Blown fuse.
5. Corroded
battery terminals.
6. Loose or damaged wiring.
7. Faulty ignition switch.
8. Faulty solenoid or starter.
9. Faulty operator presence
switch(es).
1. Weak or dead battery.
2. Corroded
battery terminals.
3. Loose or damaged wiring.
4. Faulty solenoid or starter.
1. Fill fuel tank.
2. See "TO START ENGINE"
in Operation section.
3. Wait several minutes
before attempting to start.
4. Replace spark plug.
5. Clean/replace
air filter.
6+ Replace fuel filter.
7. Drain fuel tank and
carburetor, refill tank with
fresh gasoline and replace
fuel filter.
8.
Check all wiring.
19. See "To Adjust Carburetor"
in Service Adjustments
section.
10. Contact a Sears or other
qualified service center.
1. Clean/replace
air filter.
2. Replace spark plug.
3. Recharge or replace
battery.
4. Replace fuel filter.
5. Drain fuel tank and refill
with fresh gasoline.
8. Check all wiring.
7. See "To Adjust Carburetor"
in Service Adjustments
section.
8. Contact a Sears or other
qualified service center.
1. Depress clutch/brake
pedal.
2. Disengage
attachment
clutch.
3. Recharge or replace
battery.
4. Replace fuse.
5. Clean battery terminals.
6. Check all wiring.
7. Check/replace
ignition
switch.
8. Check/replace
solenoid or
starter.
9. Contact a Sears or other
qualified service center.
1. Recharge or replace batter
2. Clean battery terminals.
3. Check all wiring.
4. Check/replace
solenoid or
starter.
28
Advertisement
