Advertisement
• The average lawn should be cut to
approximately
2-1/2 inches during the
cool season and to over 3 inches
during hot months.
For healthier and
better looking lawns, mow often and
after moderate growth.
• For best cutting performance,
grass
over 6 inches in height should be
mowed twice• Make the first cut
relatively high; the second to desired
height.
TO ADJUST GAUGE WHEELS
Gauge wheels
are properly adjusted
when they are slightly off the ground
when mower is at the desired cutting
height in operating position• Gauge
wheels then keep the deck in proper
position to help prevent scalping in most
terrain conditions.
NOTE: Adjust gauge wheels with tractor
on a flat level surface.
1. Adjust mower to desired cutting height
(See "TO ADJUST MOWER CUTTING
HEIGHT" in the Operation section of
this manual)•
2• With mower in desired height of cut
position, gauge wheels should be
assembled so they are slightly off the
ground• Install gauge wheel in
appropriate
hole with shoulder belt, 3/
8 washer, and 3/8-16 Iocknut and
tighten securely•
3. Repeat for opposite side installing
gauge wheel in same adjustment
hole.
Mountir
Locknut
Gauge Wheel
TO OPERATE MOWER
Your tractor
is equipped with an operator
presence sensing switch• Any attempt by
the operator to leave the seat with the
engine running and the attachment
clutch engaged will shut off the engine•
1. Select desired height of cut.
2_ Start mower blades by engaging
attachment clutch control•
TO STOP MOWER BLADES -
disengage attachment
clutch control
_CAUTION:
Do not operate the mower
without either the entire grass catcher, on
mowers so equipped, or the deflector
shield in place•
Attachment
Clutch Lever
Attachemnt
E gaged __
_Lift
Lever High
Position
__"_'_
_
Position
._
l
Position
'Disengaged
I '
:
Position
:
i
,,_ !
'
_
Deflector
Shield
IJ
TO OPERATE ON RILLS
,_CAUTION:
Do not drive up or down
hills with slopes greater than 15 ° and do
not drive across any slope.
• Choose the slowest speed
before
starting up or down hills•
• Avoid stopping or changing speed on
hi_ls.
• If slowing is necessary, move throttle
control lever to slower position•
• If stopping is absolutely
necessary,
push clutch/brake
pedal quickly to
brake position and engage parking
brake.
• Move gearshift
lever to 1st gear• Be
sure you have allowed room for tractor
to roll slightly as you restart movement•
• To restart movement, slowly release
parking brake and clutch/brake
pedal.
• Make all turns slowly.
TO TRANSPORT
• Raise attachment
lift to highest position
with attachment lift control.
• When pushing or towing your tractor,
be sure gearshift lever is in neutral (N)
position•
• Do not push or tow tractor at more than
five (5) MPH.
NOTE: To protect hood from damage
when transporting
your tractor on a truck
or a trailer, be sure hood is closed and
secured to tractor• Use an appropriate
means of tying hood to tractor (rope, cord,
etc.).
14
Advertisement
