Philips sonicare ProtectClean HX6839/66 Manual page 36

English
light and battery light will also blink green 2 times in unison
to confirm activation.
- Triple tone of high-med-low means the pressure sensor
feature has been deactivated. The brush head replacement
light and battery light will also blink amber 1 time in unison to
confirm deactivation.
If you continue holding the power on/off button after the three
short beeps, the activate/deactivate sequence repeats.
Battery status and charging
1 Put the plug of the charger in an electrical outlet.
2 Place the handle on the charger.
- The charger will emit 2 short beeps to confirm that the
handle is placed properly.
- The flashing light of the battery level indicator shows that
the toothbrush is charging.
- When handle is fully charged on the charger, the battery
light shows solid green for 30 seconds and switches off.
Note: Your toothbrush comes pre-charged for first use. After first
use, charge for at least 48 hours.
Battery status (when handle is not on charger)
When removing the Philips Sonicare from the charger, the battery
light at the bottom of the toothbrush will indicate the status of the
battery life.
- Solid green LED: full battery
- Flashing green LED: medium battery
- Flashing amber LED and three beeps: low battery
- Flashing amber LED and two sets of five beeps: No brushing
sessions left (charge toothbrush)
35