Table of Contents
Advertisement
SETUP INSTRUCTIONS ( continued )
Motor installation:
1.
Make sure a hose o-ring (6) is on the pump motor outlet. Connect the sand filter
interconnecting hose (13) to the pump motor outlet with a hose clamp (see drawing 11).
2.
Connect the pump motor unit to the tank support base (see drawing 12.1).
IMPORTANT: Some countries, especially in the European community, require the
product to be secured to the ground or to a base in a permanent upright position.
Check your local authorities to determine if there is a regulation in your area regarding
above-the-ground swimming pool filter-pumps. If yes, then the product can be
mounted to a platform using the two holes located in the base. See drawing 12.2.
The product can be mounted on a cement base or onto a wooden platform to prevent
accidental falling over.
•
The mounting holes are 6.4 mm in diameter and spaced 163 mm apart.
•
Use two bolts and lock nuts with a maximum of 6.4 mm in diameter.
3.
Make sure a hose o-ring (6) is on the 4-way valve inlet connection. Connect the sand
filter interconnecting hose (13) to the 4-way valve inlet connection with a hose clamp (see
drawing 13).
13
SAVE THESE INSTRUCTIONS
(354GS) MODEL SF40220RC SAND FILTER PUMP ENGLISH 7.5" X 10.3" PANTONE 295U 05/26/2022
11
12.2
13
354
English
GS
12.1
13
Page 9
Advertisement
Table of Contents
