Table of Contents
Advertisement
POOL CARE & CHEMICALS
•
All pools require care to keep the water clear and hygienically clean. With proper chemical
control, your filter will help attain this objective. Consult your pool supply dealer for
instructions regarding the proper use of chlorine, algaecide and other chemical agents
required for sparkling clear water.
•
Keep pool chemicals away from children.
•
Do not replenish chemicals in pool while pool is occupied. Skin or eye irritations could occur.
•
Daily pH checking and chemical treatment of the water is very important and cannot be
overemphasized. Chlorine, algaecide and maintenance of proper pH levels are required when
filling the pool as well as during the season. Consult your local swimming pool supply store
for instructions.
•
The season's first filling of the pool may have brackish water requiring extra water additives
and extra filtering time. Do not allow swimming in pool until the pH level is balanced. Consult
your local swimming pool supply store for instructions.
•
Chlorinated water may damage lawns, gardens or shrubbery as children play in the pool and
splash water outside the pool. Lawn areas underneath the pool liner will be destroyed. Note
that some types of grass may grow through the liner.
•
Filter run time depends on pool size, weather and usage level. Experiment with various run
times so as to produce clean clear water.
•
European standard EN16713-3 lists some additional pool water quality and water treatment
information that can be found at www.intexcorp.com/support.
Concentrated chlorine solutions may damage the pool liner. Always follow
the chemical manufacturer's directions, and the health and hazard warnings.
LONG TERM STORAGE & WINTERIZATION
Allowing the water to freeze will damage the sand filter and void the warranty.
1. Before emptying your pool for long term storage, or relocation, be sure the water is directed
towards an acceptable drain water receptacle away from the house. Check local regulations
for specific directions regarding disposal of swimming pool water.
2. Switch off the unit, and disconnect power cord from electrical outlet.
3. When the pool is empty, disconnect all hoses from pump and remove the strainers from the
pool wall.
4. In a counter clockwise motion unscrew the drain valve cap (9) from the drain valve to
thoroughly drain the tank. The drain valve is located at the bottom of the filter tank.
5. Disassemble the pump motor from the tank base.
6. Leave sand filter pump pieces and hoses outside to thoroughly air dry.
7. Coat the following o-rings with petroleum jelly for long term storage:
• Hose o-rings (6).
• Air release valve o-ring (15).
8. Depress the 4-way valve handle and rotate so as to set the pointer on the valve top "N"
position. This allows the water to drain from the valve. Leave the 4-way valve in this inactive
position.
9. It is best to place all dry pieces and pump motor in the original packaging for storage. To
avoid condensation or corrosion problem, do not cover or wrap pump motor with plastic bags.
10. Store the pump motor and accessories in a dry place. The storage's temperature should be
controlled, between 0 degrees Celsius (32 degrees Fahrenheit) and 40 degrees Celsius
(104 degrees Fahrenheit).
11. Cover the tank with a tarpaulin or plastic sheet to protect it from the weather.
SAVE THESE INSTRUCTIONS
(354GS) MODEL SF40220RC SAND FILTER PUMP ENGLISH 7.5" X 10.3" PANTONE 295U 05/26/2022
CAUTION
CAUTION
354
English
GS
Page 16
Advertisement
Table of Contents
