Samsung WF60F4E0W0W User Manual page 18

CAUTION: Do not put the drain hose
in places of stagnant water or ponding.
The water may flow back to the washing
machine.
STEP 5 - Powering your washing machine
Plug the power cord into a wall socket, an AC 220 - 240 V / 50 Hz approved electrical outlet protected by a fuse or
circuit breaker. (For more information on the electrical and grounding requirements, refer to the "Electrical supply
and grounding" section on page 12.)
Test run
Make sure that you install your washing machine correctly by running the Rinse+Spin cycle after the
installation is complete.
STEP 6 - Running Calibration Mode
Your Samsung washing machine detects the weight of the laundry automatically. For a more accurate weight
detection, it is recommended running Calibration Mode immediately after installing the washing machine. Follow
the steps below to run Calibration Mode.
Before running Calibration Mode, make sure that there is nothing in the drum or on top of the washing
machine.
1. Turn the washing machine off.
2. Press the Power button while holding down the Temp. and Delay End buttons simultaneously. The washing
machine will turn on and "CLB" will appear on the display.
3. Press the Start/Pause button to start Calibration Mode.
4. The drum will rotate clockwise and counter-clockwise for about 3 minutes.
5. When Calibration Mode is complete, "End" (or "0") appears on the display and the washing machine will turn
off automatically.
6. The washing machine is now ready for use.
Untitled-36 18
English - 18
2017-03-22 8:11:54