Table of Contents
Advertisement
POOL SETUP ( continued )
3.
Starting with one side, slide the "A" beams first into the
sleeve openings located in each corner. Continue with "B"
beam snapping into the "A" beam. Insert the beam
through the "T" joint at each liner sleeve middle opening
(see drawing 3).
Continue inserting all "A-B & C-D" beams into the
sleeve openings. Start the "C-D" combination for pool's
short sides by inserting the "C" beam first into the
opening. The combinations for beams are different for
different sizes of pools, see the chart below for detail.
Size of Pool
86-5/8" x 59" x 23-5/8" (220cm x 150cm x 60cm)
102-1/2" x 63" x 25-5/8" (260cm x 160cm x 65cm)
118" x 78-3/4" x 25-5/8" (300cm x 200cm x 65cm)
118" x 78-3/4" x 29-1/2" (300cm x 200cm x 75cm)
4.
Connect the corner joints (5) to the horizontal beams at
4 corners. Secure the joints with the pins (6) by inserting
them into the pre-drilled holes (see drawing 4).
5.
Connect the vertical corner legs (10) to the corner top rail
joints (5) (see drawing 5).
NOTE: The vertical corners legs (10) are marked with the
letter (E). Make sure they are not used as side legs (8) or
vice versa.
6.
Attached the leg's end cap (11) to the bottom of the
vertical legs (10) (see drawing 5).
SAVE THESE INSTRUCTIONS
(123IO) SMALL RECTANGULAR METAL FRAME POOL ENGLISH 7.5" X 10.3" PANTONE 295U 05/20/2022
No. of "Inverted T"
No. of "Inverted T"
sides support leg
sides support Leg
on longer side
on shorter side
2
2
2
2
(A
)
(A)
(B)
Horizontal Beam
Horizontal Beam
Combinations
on longer side
on shorter side
1
A-A-B
1
A-A-B
1
A-A-B
1
A-A-B
5
(E)
123
English
A
3
7
Combinations
C-D
C-D
C-D
C-D
4
6
5
10
11
Page 8
Advertisement
Table of Contents
