Table of Contents
Advertisement
POOL SETUP ( continued )
You may have purchased this pool with the Intex Krystal Clear™ filter pump. The pump
has its own separate set of installation instructions. First assemble your pool unit and
then set up the filter pump.
Estimated assembly time 30 minutes. (Note the assembly time is only approximate and individual assembly
experience may vary.)
1. • Find a flat, level location that is free and clear of stones, branches or other sharp objects that may
puncture the pool liner or cause injury.
• Open the carton containing the liner, joints, legs, etc., very carefully as this carton can be used to store
the pool during the winter months or when not in use.
• Remove the liner (12) from carton and spread it out over
the ground cloth with the drain valve towards the draining
area. Place the drain valve away from the house. Spread it
out completely with its edges being at least 5 - 6' (1.5 - 2.0m)
from any obstacle such as walls, fences, trees, etc. Open it
up to warm it in the sun. This warming will make installation
easier. Be sure to face the end with the hose connectors
towards the electrical power source.
IMPORTANT: Always set up the pool unit with at least
2 persons. Do not drag the liner across the ground as
this can cause liner damage and pool leakage (see drawing 1).
• During the set-up of the pool liner, point the hose connections or openings in the direction of the electric
power source. The outer edge of the pool should be within reach of the pump's electrical connection.
2. Remove all the parts from the carton(s) and place them on
the ground in the location where they are to be assembled.
Check the parts listing and be sure all the pieces to be
assembled are accounted for (see drawing 2).
IMPORTANT: Do not start assembly if any pieces are
missing. For replacement pieces call the Consumer
Service telephone number in your area.
After all pieces are accounted for, move the pieces away
from the liner for of installation.
NOTE: Sprinkle some talcum powder over the horizontal
beams before sliding them into the pool liner sleeve.
This will make removal of the beams from the liner
easier during the disassembly of the pool.
SAVE THESE INSTRUCTIONS
(123IO) SMALL RECTANGULAR METAL FRAME POOL ENGLISH 7.5" X 10.3" PANTONE 295U 05/20/2022
(1.5 - 2.0m)
5 - 6'
(1.5 - 2.0m)
LINER
ELECTRICAL SOURCE
(A)
(A)
(B)
(D)
(C)
(A)
(A)
(B)
86-5/8" X 59" X 23-5/8"
102-1/2" X 63" X 25-5/8"
118" X 78-3/4" X 25-5/8"
118" X 78-3/4" X 29-1/2"
123
English
A
1
5 - 6'
5 - 6'
(1.5 - 2.0m)
2
(C)
(D)
Page 7
Advertisement
Table of Contents
