DeLonghi DINAMICA plus Instructions For Use Manual page 22

DISPLAYED MESSAGE
INSERT MILK CONTAINER
INSERT INFUSER ASSEMBLY
WATER CIRCUIT EMPTY
PRESS OK TO START
PRESS OK TO CLEAN OR TURN
DIAL
POSSIBLE CAUSE
The milk container (E) is missing or not correct-
ly in place.
The infuser (A20) has not been replaced after
cleaning.
The water circuit is empty
A new water softener filter has been inserted
(D4)
The milk container has been inserted with
the froth adjustment dial (E1) in the CLEAN
position.
REMEDY
Insert the milk container, pushing it as far as
it will go.
Insert the infuser as described in section "12.9
Cleaning the infuser".
Press the selector corresponding to "OK" to
deliver water from the spout (D6) until it flows
out normally.
If the problem persists, make sure the water
tank (A17) is fully inserted.
Make sure you have followed the instructions
for inserting the new filter (section "15. Water
softener filter"). If the problem continues,
remove the filter (section 15.3 Removing the
filter).
To proceed with the CLEAN function, press the
selector corresponding to "OK", or turn the froth
adjustment dial to one of the milk positions.
22