Craftsman 917.27066 Owner's Manual page 10

CHECK BRAKE SYSTEM
After you learn howto operateyour
tractor,checkto see that the brakeis
properlyadjusted.See
'qO ADJUST
BRAKE" in the Service and Adjustments
section of this manual.
INSTALL MULCHER PLATE
• Install two latch hooks to mulcher plate
using screw, washer, lock washer, and
weld nut as shown.
NOTE: Pre-assemble weld nut to latch
hook by inserting weld nut from the top
with hook pointing down.
• Tighten hardware securely.
• Raise and hold deflector shield in
upright position.
• Place front of mulcher plate over front of
mower deck opening and slide into
place, as shown.
• Hook front latch into hole on front of
mower deck.
• Hook rear latch into hole on back of
mower deck.
CAUTION; Do not remove discharge
guard from mower. Raise and hold guard
when attaching mulcher plate and allow it
to rest on plate while in operation.
TO CONVERT TO BAGGING OR
DISCHARGING
Simply remove mulcher plate and store in
a safe place. Your mower is now ready for
discharging or installation of optional
grass catcher accessory.
NOTE; It is not necessary to change
blades. The mulcher blades are designed
for discharging and bagging also.
Weld Nut From _ Hook
The Top _ 7Points
LockVasher _. _ Down
Weld Screw
Nat _'_ _--/_/Jl_._. _ Latch
Latch_17 / //'_t_=_ Hook
.oo XJ.J\ ,,--we,,,,,,,
Lock Washer
Washer _ _ _ Washer
Mulcher Plate _ Screw
_CHECKLIST
Before you operate and enjoy your new
tractdr, we wish to assure that you receive
the best performance and satisfaction
from this quality product.
Please review the following checklist:
J All assembly instructions have been
completed.
No remaining loose parts in carton.
,! Battery is properly prepared and
charged. (Minimum 1 hour at 6 amps).
,/Seat is adjusted comfortably and
tightened securely.
J" All tires are properly inflated. (For
shipping purposes, the tires were
overinflated at the factory).
d Be sure mower deck is properly leveled
side-to-side/front-to-rear for best cutting
results. (Tires must be properly inflated
for leveling).
,/Check mower and drive belts. Be sure
they are routed properly around pulleys
and inside all belt keepers.
J Check wiring. See that all connections
are still secure and wires are properly
clamped.
Before driving tractor, be sure free-
wheel control is in drive position.
While learning how to use your tractor,
pay extra attention to the following
important items:
J Engine oil is at proper level.
J" Fuel tank is filled with fresh, clean,
regular unleaded gasoline.
,I Become familiar with all controls - their
location and function. Operate them
before you start the engine.
,/Be sure brake system is in safe operat-
ing condition.
,I It is important to purge the transmission
before operating your tractor for the first
time. Follow proper starting and
transmission purging instructions (See
'q'O START ENGINE" and "PURGE
TRANSMISSION" in the Operation
section of this manual).
Deflector
Latch Hooks
f !0