Table of Contents
Advertisement
the engine is running, center either motion control and
move (forward or reverse); the engine should stop.
Repeat for other motion control.
5. Sitting on the seat, disengage the parking brake, move
the PTO switch to off and move the motion control
levers to neutral lock position. Try starting the engine;
the engine should not crank.
Driving Forward or Backward
The throttle control regulates the engine speed as
measured in rpm (revolutions per minute). Place the
throttle control in the fast position for best performance.
Always operate in the full throttle position
Caution
Machine can spin very rapidly. Operator may lose
control of machine and cause personal injury or
damage to machine.
Use caution when making turns.
Slow the machine down before making sharp
turns.
Driving Forward
1. Release the parking brake; refer to Releasing the
Parking Brake, page 17.
2. Move levers to the center, un-locked position.
3. To go forward, slowly push the motion control levers
forward (Fig. 17).
Note: Engine will kill if traction control levers are moved
with parking brake engaged.
To go straight, apply equal pressure to both motion control
levers (Fig. 17).
To turn, release pressure on the motion control lever
toward the direction you want to turn (Fig. 17).
The farther you move the traction control levers in either
direction, the faster the machine will move in that
direction.
To stop pull the motion control levers to neutral.
3
4
Figure 17
1. Motion control
lever—neutral lock
position
Driving Backward
1. Move levers to the center, unlocked position.
2. To go backward, slowly pull the motion control levers
rearward (Fig. 17).
To go straight, apply equal pressure to both motion control
levers (Fig. 17).
To turn, release pressure on the motion control lever
toward the direction you want to turn (Fig. 17).
To stop push the motion control levers to neutral.
Stopping the Machine
To stop the machine, move the traction control levers to
neutral and move to locked position, disengage the power
take off (PTO), and turn the ignition key to off. Also set
the parking brake when you leave the machine; refer to
Setting the Parking Brake, page 17. Remember to remove
the key from the ignition switch.
Caution
Children or bystanders may be injured if they
move or attempt to operate the tractor while it is
unattended.
Always remove the ignition key and set the
parking brake when leaving the machine
unattended, even if just for a few minutes.
Adjusting the Height-of-Cut
The height-of-cut is adjusted from 1-1/2 to 4-1/2 inch
(38 to 114 mm) in 1/4 inch (6 mm) increments by
relocating clevis pin in different hole locations.
20
2
1
m–2715
2. Center unlock position
3. Forward
4. Backward
Advertisement
Table of Contents
