Dell W4X15 Owner's Manual page 11

Item Indicator, Button, or
Connector
3 System identification
button
4 Video connector
5 LCD menu buttons
6 LCD panel
7 USB management port/
iDRAC managed USB
port
8 USB port
9 Information tag
10 Hard drives
Icon Description
Press the system ID button:
• To locate a particular system within a rack.
• To turn the system ID on or off.
To reset iDRAC, press and hold the button for
more than 15 seconds.
NOTE: To reset iDRAC using system ID,
ensure that the system ID button is enabled in
the iDRAC setup.
NOTE: If the system stops responding during
POST, press and hold the system ID button
(for more than five seconds) to enter the BIOS
progress mode.
Use the video/VGA port to connect a display to the
system. For more information about the supported
video/VGA port, see the Technical specifications
section.
Press the LCD menu buttons to navigate the
control panel LCD menu.
Displays system ID, status information, and system
error messages. For more information, see the LCD
panel section.
NOTE: LCD panel is not available in a cabled
hard drive system.
The USB management port is USB 2.0 compliant.
Enables you to connect USB devices to the system
or provides access to the iDRAC Direct features.
For more information, see the Integrated Dell
Remote Access Controller User's Guide at
Dell.com/idracmanuals.
Use the USB 2.0 port to connect USB devices to
the system. This port is 4-pin, USB 2.0 compliant.
Displays system information such as service tag,
NIC, and MAC address.
NOTE: The information tag is a slide-out label
panel.
Up to four 3.5-inch hard drives or solid state drives
(SSD).
For information about the supported hard drives,
see the Technical specifications section.
11