Table of Contents
Advertisement
s
Menu structure:
MODE
Normal
operating mode
(temperature)
1.
Press the MODE button while in normal operating mode to switch
to "configuration layer" mode.
2.
Use ▲▼ to select the configuration layer for the parameter you
wish to set.
3.
Press MODE to confirm. Press ▲▼ to select the particular pa-
rameter.
4.
Press MODE to confirm. Press ▲▼ to adjust the parameter val-
ue.
5.
Press MODE again to end. Press ▲▼ to select
6.
Now use MODE to either apply the changes you have made to
the settings [
END
[
]. After that, the display panel will resume showing the tem-
perature reading.
Parameter
EPS.1
AO1._
AO1.~
AO1.4
AO1.T
MODE
Select
config. layer
C000-
C999
▲▼
SAVE
] or to close without saving these changes
configuration
layer
C001
C010
C010
C010
C100
12
Operating Manual MPA
MODE
Select
parameter
EPS
▲▼
Explanation
Emissivity spectral channel 1
(see chapter 0).
Lower limit of temperature span
analogue output Ao1 (see chapter
6.5).
Upper limit of temperature span
analogue output Ao1
(see chapter 6.5).
Hardware configuration of the ana-
logue output 0-20 mA, 4-20 mA
(see chapter 6.5).
Temperature measurement simula-
tion to verify signal transmission
(see chapter 6.6).
Adjust
parameter
99.9
▲▼
END/SAVE.
Advertisement
Table of Contents
