Friedrich PDH15K5 Installation & Operation Manual page 28

ADDITIONAL ACCESSORIES
MODEL NUMBER
SLEEVE EXTENSION RETROFIT KIT Galvanized zinc coated
steel, 2.4" sleeve extension attached to the room side of the
PXSE
sleeve to allow for the installation of a PD-Series Friedrich
PTAC in a T-Series sleeve.
LATERAL DUCT ADAPTER Attaches to the PTAC/PTHP
unit and provides a transition to direct up to 35% of the total
PDXDA
CFM to a secondary room, either left or right of the unit. Kit
includes duct plenum with discharge grille and internal baffl e,
adapter and end cap.
LATERAL DUCT EXTENSION A three-foot insulated
plenum that attaches to the left or right side of the duct
PDXDE
adapter. The extension can be cut to length by the installer.
Maximum allowable straight extension is 15 feet.
CONDUIT KIT WITH JUNCTION BOX Hard wire conduit kit
with junction box for 208/230V and 265V units (subbase not
PXCJ
required). Kit includes a means of quick disconnect for easy
removal of the chassis. *Required for 265V installations.
POWER CORD RETROFIT Replaces LCDI power cord on
PXPC
230V models when unit is used with a subbase. PXPC15 is
15/20/30 used with 15 amp 2.5 kW units. PXPC20 is used with 20 amp
3.4 kW units. PXPC30 is used with 30 amp 5.0 kW units.
REMOTE CONTROL KIT Comes with one hand-held remote
PDXRC
for control of the PTAC unit.
CHASSIS OPTIONS
DESIGNATOR
S
STANDARD UNIT Standard PTAC/PTHP chassis. Can be 230/208V or 265V, electric or heat pump.
28
DESCRIPTION
DESCRIPTION
920-087-06
PHOTO
PXPC30
Temperature
Cooler Warmer
Power
Heat
Cool
Low Fan High
Fan Only Fan