Connecting To A Wireless Network - ZyXEL Communications Prestige 2000W_V2 Quick Start Manual

2 Connecting to a Wireless Network

Press the Power/End key for two seconds to turn on the Prestige. The Prestige searches for the available
wireless network with the best signal. It then restarts and attempts to connect to the wireless network.
If the LCD screen displays Not Registered, the Prestige is connected to the Internet
and you can skip to Section
Note: If the LCD screen displays Registered, skip to
If any other message displays or you want to select a specific network, please
continue with the following steps.
1 In the main screen, press the Left key to enter the menus.
2 Use the down arrow key to scroll to Wireless and press the OK key.
3 Use the down arrow key to scroll to Site Survey and press the OK key.
The Prestige checks for and displays a list of available wireless networks and
each one's signal strength.
4 Scroll to the name of the wireless network that you want to use and press the
OK key. If a "W" appears next to the network name, or if you know WEP
encryption is required for your network, then continue with
Otherwise, skip to
Prestige 2000W_V2 Quick Start Guide
4.
Section 2.2.
Section 5.
Section 2.1,
5
12:00
ZyXEL
Not registered
Menu Names
12:00
ZyXEL
Net failed (DHCP)
Menu Names
7. Wireless
8. Restart
1. Information
Select Back
1. Site Survey
2. SSID
3. Network Mode
Select Back
ZyXEL USA 99 W
ABC123 90
123ABC 85
Select Back