Zenith XBR411 Manual page 155

PROTECTION, MAINTENANCE AND CHECK OF VIDEO FUNCTION
5-2) Grease Applications
(1) Grease Application Method
Apply grease by using a cloth swab or brush. Care must
be exercised so that excess quantity should not be
used. If the excessive quantity is applied, wipe it with
the gauze soaked in alcohol (Isopropyl Alcohol).
NOTE: POSITION OF GREASE APPLICATION
(1) Inner Side Surface and Top
Surface of Loading Path
(2) Stable Adhesion Part of Base
P2, P3
(3) Arm Pinch Shaft
2
1
Chassis (TOP)
Gear Part
Cam Part
(PL-433.Yellow)
Gear Part
Cam Part Side Application
(PL-433.Yellow)
(KG-684G.Green)
Gear Sector
Boss Part Side Wall
(PL-433.Yellow)
Gear Part Side Application
(PL-433.Yellow)
Base Loading
Inner Surface of
(KG-684G.Green)
Chassis (L)
(4) Gear Wheel Shaft
(5) Reel S. T. Shaft
(1) (2) (3) (4): KG-684G
(Green)
(5): PL-433 (Yellow)
4
3
5
Gear Cam
Gear Drive
Guide Rail
Chassis (R)
(2) Regular Grease Application
Apply grease to the designated application position
every 500 hour.
(1) Inner Side Surface and Top
Surface of Loading Path
(2) Stable Adhesion Part of Base
P2, P3 Coil
(3) Gear Cam Shaft
(4) Gear Drive Shaft
(5) Clutch Shaft Groove
3
4
6
Chassis (Bottom)
Cam Part
(KG-684G , GREEN)
Lever, Brake Driving Cam Part
Side Wall Guide Part
4-21
(6) Guide Part on the Plate Slider
Side Wall (Left)
(7) Guide Part on the Plate Slider
Side Wall (Right)
(1) (2) (3) (4) (5) (6) (7): KG-
684G (Green)
2
5
7
Cam Part
(KG-684G , GREEN)
Gear Rack F/L
Lever Tension Driving Cam Part
Gear Sector Driving Part
Lever F/R Driving Part
Side Wall Guide Part
Lever, Spring Driving Part
Plate Slider
1