Processing Wooden Workpiece 1 - Parkside 382543 2110 Operating Instructions Manual

Wood thickness
12–14 mm
15–18 mm
19–30 mm
♦ Mark your wooden workpieces, e .g . with and , so you can tell
them apart (see Fig . A) .
♦ Mark the places on the wooden workpieces that you want to join,
e .g . with a

Processing wooden workpiece 1

♦ Clamp the wooden workpiece , e .g . to a work table (see Fig . A) .
♦ Set the drilling depth for wooden workpiece . Use a drill with a
depth stop . Measure the dowel length . For face joints, set half the
dowel length plus 1 mm plus 26 mm for the thickness of the product
itself . For corner and T-joints, set the dowel length plus 6 mm plus
26 mm for the thickness of the product itself and minus the thickness
of wooden workpiece .
♦ Place the product on the front edge of wooden workpiece and
clamp it between the guide bolts . Depending on which drill bush
you are using, the product must be applied accordingly (see Fig . B) .
♦ Secure the product to the wooden workpiece by pressing from
the side .
♦ Insert the drill into the drill bush and drill a hole (see Fig . C) .
♦ Fill the drill holes with wood glue .
♦ Insert the dowels into the drill holes .
PUD 30 A1
(see Fig . A) .
∅ Drill bush/dowel
6 mm
8 mm
10 mm
GB │ IE │ 5 ■