Follow the instructions in this section to prevent water leaks. If you are unsure, ask a service
agent to connect the hoses.
Hoses and cable lengths
Left side connections
~ 145 cm
~ 100 cm
Water supply hose
Caution
Do NOT connect the water supply
-
hose to a combination tap.
-
Do NOT twist, squash, modify, or
cut the hose.
-
Optimum mains water pressure is 0.1 -
1.0 MPa. If the water pressure exceeds
this value, install a pressure reducing
valve.
-
Waterflow from the tap should be more
than 5 L/min.
Connecting the water supply hose
1.
Attach one end of the hose to
the water inlet on the back of the
appliance and tighten the joint by
hand.
Connecting Hoses and Power Supply
~ 95 cm
Right side connections
~ 140 cm
~ 95 cm
~ 155 cm
2.
Attach the other end of the hose to
the tap and tighten it the same way.
Make sure the
filter is inside
the hose.
3.
Open the tap slowly and make sure
that there are no leaks around the
joints.
The joints are subject to water pressure.
Installation Instructions - 37
3/4"
min. 10 mm
2018-8-1 14:07:51