Breville BRITA HotCup Manual page 5

BEFORE USING YOUR HOTCUP
TIME
• Remove your HotCup ™ water dispenser carefully from the box. Remove any
packaging and promotional material and position your HotCup
dry, level, secure work surface away from the edge.
• Follow the instructions below and discard the first full tank of water. This will remove
any residues that may remain from the manufacturing process.
• Fit the filter funnel and the BRITA
—see pages 6 and 7.
USING YOUR HOTCUP WATER DISPENSER
™
Always position your HotCup ™
button cannot be accidentally operated, especially by children. As you use your
HotCup water dispenser, a certain portion of the water boiled will be transferred
™
back to the water reservoir. This will mean the water reservoir may become hot.
Always use care when handling your HotCup
1. Press the lid flap release button to open the lid flap.
2. Fill the filter funnel from your cold tap up to the MAX mark on the filter funnel. Allow
the water to filter through into the water chamber. Repeat until the water level in the
chamber is no higher than the MAX marking on the water chamber.
3. Close the lid and press the stop button. This will make sure that your HotCup
dispenser will not immediately start a boil cycle when you place it onto the power
base.
4. Connect your HotCup water dispenser to a mains supply socket.
™
5. Place a suitable cup or container with a tea bag, coffee, sugar, etc. below the
dispensing nozzle. Never operate your HotCup
suitable container placed below the dispensing nozzle. Adjust the dispensing control
to the required setting. The control adjusts the quantity of boiling water dispensed by
your HotCup ™ water dispenser. For smaller cups like teacups, set the control towards
the setting; for larger cups like coffee mugs, set the control towards the
If you are not sure which setting to use, it's best to use a lower setting until you gain
experience using your HotCup
™
6. Press the start button. The body will light up blue and your HotCup
will start to boil.
7. The selected quantity of boiling water will be dispensed into the cup. Your HotCup
water dispenser is now ready to use again. If, after just having boiled, the start button
doesn't operate, simply wait a few seconds before trying it again.
STOPPING YOUR HOTCUP WATER DISPENSER
™
If you have started the boil procedure and then decide you want to stop your HotCup
water dispenser for any reason, simply press the stop button. You can also stop water
that is being dispensed by pressing the stop button. The boiled water will be safely
transferred back into the water reservoir.
8
VKJ367_22EM1 (UK).indd 8-9 VKJ367_22EM1 (UK).indd 8-9
WATER DISPENSER FOR THE FIRST
™
™ water dispenser on a
MAXTRA+ water filter and set the BRITA
® ®
water dispenser in such a way that the start
water dispenser.
™
water dispenser without a cup or
™
water dispenser.
water dispenser
™
Memo
®
™ water
setting.
™
™
SMALL LARGE
CUP CUP
9
3/3/2022 2:44:43 PM 3/3/2022 2:44:43 PM