Ariens 921017 Owner's/Operator's Manual page 12

.
921013, 022, 023, 031
2
OS7061
1. Chute Crank
2. Control Panel
3. Hairpin
Figure 12
6. Orient the chute and pedestal to its most
vertical position and tighten pedestal
hardware to 15 – 31 lbf-ft (20 – 42 N•m)
(Figure 11).
Install Discharge Chute, Chute
Control, and Chute Rod
(921017, 018)
(Figures 13, 14, 15, 16 and 17)
1. Grease underside of discharge chute
ring (if not already greased) (Figure 11).
2. Remove mounting hardware from auger
housing (Figure 11).
3. Install discharge chute over opening in
the auger housing. Finger tighten the
mounting hardware removed in step 2
(Figure 11).
NOTE: Leave discharge chute pedestal loose
to help install the chute rod and connect it to
the control assembly.
4. Remove rubber grommet from the
control panel by pinching the long-edged
sides together and pulling upward. Save
rubber grommet (Figure 13).
3
1
1
3
1. Chute Control Assembly Lever
2. Poly Liner Bushing
3. Control Assembly
4. Large Hairpin
5. Rubber Grommet
5. Remove and save the large hairpin from
the control assembly (Figure 13).
6. Route chute control assembly below the
crossbar of the lower handlebar
(Figure 15). Slide the lever of the
assembly through the underside of the
hole in the control panel (Figure 14).
7. Insert the chute control assembly into
the control assembly mounting hole
under the control panel (Figure 14).
NOTE: Be sure the poly liner bushing is
properly seated in the control assembly
mounting hole.
NOTE: Mounted control lever should tip
towards the engine.
GB - 12
2
Figure 13
5
4