Ariens 921017 Owner's/Operator's Manual page 11

Install Remote Wheel
Lock Trigger Assembly
(Figure 10)
NOTE: Remote wheel lock trigger assembly
comes attached to the Sno-thro unit.
1. Attach remote wheel lock trigger
assembly to upper handlebar assembly
using one 1/4 in-20 oval head machine
screw and one 1/4 in. internal locking
washer (Figure 10).
2
3
1
1. Remote Wheel Lock Trigger
2. Oval Head Machine Screw
3. Internal Locking Washer
Figure 10
Install Discharge Chute and
Discharge Chute Crank
(921013, 022, 023, 031)
(Figure 11 and 12)
1. Grease underside of discharge chute
ring (if not already greased).
2. Remove mounting hardware from auger
housing (Figure 11).
3. Install discharge chute over opening in
the auger housing. Finger tighten the
mounting hardware removed in step 2.
NOTE: Leave discharge chute pedestal loose
to help install the chute crank.
OS7040
4
1. Mounting Holes
2. Discharge Chute
3. Chute Pedestal
4. Discharge Chute Ring
4. Insert the short end of the chute crank
into the hole in the front of the control
panel.
NOTE: Be careful not to damage nylon
bushing when attaching crank to the control
panel.
5. Connect the chute crank to the pinion
gear on chute with hairpin.
GB - 11
2
Figure 11
1
3
1
OS7045