Craftsman 247.881733 Operator's Manual page 8

1. Remove wing nut and hex screw from chute control head and clevis pin and
cotter pin from chute support bracket. Position chute (forward-facing) over
chute base. See Figure 4.
2. Place chute onto chute base and secure chute control head to chute support
bracket with clevis pin and cotter pin removed in Step 5. See Figure 5.
3. Finish securing chute control head to chute support bracket with wing nut
and hex screw removed in Step 5. See Figure 6.
4. Insert the chute directional control into the support bracket on the rear of
the dash panel. See Figure 7.
5. Remove the hairpin clip from the rear of the chute control head.
Chute
Chute Base
Chute Control Head
Chute Support
Bracket
Figure 4
Figure 5
ASSEMBLY
8
Figure 6
Figure 7