Advertisement
TO INSTALL BOWL
Position the template and align with
drain hole.
Mark down the position of foot and 5
holes.
Drive holes on ground with the driver
of 10mm (3/8"), then insert anchor to
holes.
Install brackets.
Firmly press the toilet gasket onto the
toilet outlet of plastic trap.
NOTE 1:
Wax ring type toilet gasket
should not be installed at temperatures
o
less than 21 C.
NOTE 2:
If you are using a toilet
gasket with an integral plastic sleeve,
make sure the gasket is positioned
with the sleeve facing away from the
toilet.
Install plastic to ground and mounted
with 3 set of bolts firmly.
NOTE: Must use the toilet installation
gasket ring (not supplied) to seal the
area where the waste pipe contacts
the construction section to avoid
leakage.
1203790-T01-A
Drain Hole
Fig.#4
4
3/8
10mm
Fig.#5
5
Fig.#6
6
Plastic Trap Outlet
Toilet Gasket
Fig.#7
7
Fig.#8
8
-4-
10mm
1
o
21
C
2
3
)
(
Advertisement
