Standard Horizon ECLIPSE + GX1250SA Owner's Manual page 10

WX Key
Immediately recalls the previously selected NOAA weather channel
from any channel location.
Secondary use
1. Holding down the 16/9 key while pressing the WX key changes the
mode from USA to International or Canadian.
2. Holding down the WX and SCAN key while turning the power on resets
the microprocessor and erases scan channels from memory. This clears
the memory and establishes the factory-set defaults. For a list of these
defaults, see the section on Resetting the Transceiver's Microprocessor.
SCAN Key
1. Starts and stops scanning of programmed channels.
2. Memorizes the selected channel into the transceivers scan memory
for scanning. When pressed and held down again it, DELETES the
channel from the scan memory.
Secondary use
1. If held while the UP or DOWN key is pressed, the transceiver will
show the channels in scan memory. This function will not work if the
unit is scanning.
H/L Key
Toggles between high and low power. When the H/L key is pressed
while the transceiver is on channel 13 or 67, the power will temporarily
switch from LO to HI power until the PTT is pressed. The H/L key does
not function on transmit inhibited and low power only channels.
UP and DOWN
The UP and DOWN
r EXTERNAL SPEAKER JACK
Connects an optional external speaker to the transceiver. Use a
speaker with an impedance of 4 or 8 ohms, with an RCA phono plug.
t ANTENNA JACK
Connects an antenna to the transceiver. Use a marine VHF antenna
with an impedance of 50 ohms.
p a g e 8
Keys
keys are used to select channels.
Owner's Manual GX1250SA