–
Position the vehicle vertically.
–
Remove screw cap
–
Press the brake piston back into the basic position and ensure
that brake fluid does not flow out of the brake fluid reservoir;
extract some if necessary.
Info
Make sure that you do not press the brake caliper
against the spokes when pushing back the brake piston.
V01774-10
–
Remove cotter pin
linings.
–
Clean the brake caliper and the brake caliper bracket.
E00351-10
–
Check that spring plate
sliding plate
rectly.
E00352-10
–
Insert the new brake linings, insert the pin, and mount the cot-
ter pins.
Info
Always change the brake linings in pairs.
–
Operate the foot brake lever repeatedly until the brake lin-
ings are in contact with the brake disc and there is a pressure
point.
E00353-01
1
2
with membrane
3
4
, pull out pin
, and remove the brake
5
in the brake caliper and brake pad
6
in the brake caliper bracket are seated cor-
BRAKE SYSTEM 13
and the O-ring.
111