Stihl MS 462 Instruction Manual page 33

11 Operating the Saw
1
1 Normal tree
A normal tree is vertical and has an even crown.
2 Leaner
A leaner stands at an angle and the crown faces in the
direction of fall.
11.9.7 Felling normal, small diameter tree
A normal tree is felled with a felling cut and stabilizing strap.
This felling cut must be performed if the tree diameter is less
than the guide bar's length.
► Shout a warning.
► Plunge the guide bar into the felling cut until it is visible at
the other side of the trunk, @ 11.9.5.
► Apply the spiked bumper behind the hinge and use it as a
pivot.
► Enlarge felling cut in direction of hinge.
0458-786-0121-A
► Enlarge felling cut in direction of stabilizing strap.
2
► Insert a felling wedge. The felling wedge must match the
tree diameter and the width of the felling cut.
► Shout a warning.
► With outstretched arms, cut through the stabilizing strap
horizontally from outside at the same level as the felling
cut.
The tree falls.
11.9.8 Felling normal, large diameter tree
A normal tree is felled with a felling cut and stabilizing strap.
This felling cut must be performed if the tree diameter is
greater than the guide bar's length.
► Shout a warning.
1.
2.
► Apply the spiked bumper at the same height as the felling
cut and use it as a pivot.
1.
2.
3.
English
3.
4.
5.
31