Table of Contents
Advertisement
Power manager
en
hPower manager
Y ou can use the power manager to set the total power
P o w e r m a n a g e r
of the hob.
The hob is preset at the factory. Its maximum
performance is specified on the rating plate. You can
use the power manager to change the value in
accordance with the requirements for the relevant
electrical installation.
In order not to exceed this set value, the hob
automatically distributes the power available between
the cooking zones that are switched on.
As long as the power manager function is activated, the
output of a cooking zone may temporarily fall below the
nominal value. If a cooking zone is switched on and the
power limit is reached,
display for a short time. The appliance automatically
regulates and selects the highest possible power level.
For more information about how the total power of the
hob is changed, see section ~ "Basic settings"
24
appears in the heat setting
¬
DCleaning
:
Warning – Risk of burns!
C l e a n i n g
The appliance becomes hot during operation. Allow the
appliance to cool down before cleaning.
:
Warning – Risk of burns!
The appliance will become hot during operation. If hot
liquids penetrate the appliance, leave the appliance to
cool for at least two hours before removing the filter
cover, the metal grease filter, the container, the overflow
reservoir or the appliance housing.
:
Warning – Risk of electric shock!
Do not use any high-pressure cleaners or steam
cleaners, which can result in an electric shock.
:
Warning – Risk of electric shock!
Penetrating moisture may result in an electric shock.
Clean the appliance using a damp cloth only. Before
cleaning, pull out the mains plug or switch off the circuit
breaker in the fuse box.
:
Warning – Risk of injury!
Components inside the appliance may have sharp
edges. Wear protective gloves.
Only use a minimal amount of water when
Note:
cleaning so that no water enters the appliance.
Notes
Before cleaning the appliance, remove any jewellery
■
you are wearing on your arms and hands.
Do not use any cleaning agents while the hob is still
■
hot. This may mark the surface. Ensure that any
residue left by cleaning agents is removed.
Cleaning agents
Only use cleaning products that are suitable for this
type of hob. Follow the manufacturer's instructions on
the product packaging.
Follow all instructions and warnings included with the
cleaning products.
Suitable maintenance and cleaning products can be
purchased from the after-sales service or in our e-Shop.
Caution!
Beware of causing surface damage
Do not use:
Undiluted washing-up liquid
■
Cleaning products designed for dishwashers
■
Abrasive cleaning products
■
Pressure washers or steam jet cleaners
■
Oven cleaners
■
Corrosive or aggressive cleaners, or those
■
containing chlorine
Cleaners containing a large percentage of alcohol
■
Hard, scratchy sponges, brushes or scouring pads
■
Advertisement
Table of Contents
